Image 1 of 1
Image 1 of 1
Image 1 of 1
Image 1 of 1
Tapered stiffener plates: right-angle gussets with the sharp tip cut square and a 15 mm corner snipe at the 90° corner, so they sit over the root weld of the joint. Plasma cut from 3, 4 or 5 mm mild steel, 304 or 316 stainless and sold in packs of 4, 10 or 20.
Need other proportions, a radiused snipe or holes? See custom gusset plates.
The corner snipe clears the weld already in the joint, so the stiffener sits tight against both faces. The square-cut tip leaves room to weld round the end and avoids a sharp point. Fabricators use them to stiffen post-to-base-plate joints, brackets, beam ends and frame corners. A set of 4 suits one square base plate.
Made to order. We email your dispatch date. See delivery rates. Plain triangles: gusset plates. Plates to fit them to: base plate blanks.
What size is the snipe?
A 15 mm × 45° chamfer at the right-angle corner.
Are they rated for structural loads?
We supply the plates only and make no structural claims. Follow your engineer’s design for load-bearing work.
Are these laser cut?
No. They are plasma cut and deburred, so edges show a plasma-cut finish and are not held to laser-cut tolerances. For tight-tolerance parts, send us a drawing.
Tapered stiffener plates: right-angle gussets with the sharp tip cut square and a 15 mm corner snipe at the 90° corner, so they sit over the root weld of the joint. Plasma cut from 3, 4 or 5 mm mild steel, 304 or 316 stainless and sold in packs of 4, 10 or 20.
Need other proportions, a radiused snipe or holes? See custom gusset plates.
The corner snipe clears the weld already in the joint, so the stiffener sits tight against both faces. The square-cut tip leaves room to weld round the end and avoids a sharp point. Fabricators use them to stiffen post-to-base-plate joints, brackets, beam ends and frame corners. A set of 4 suits one square base plate.
Made to order. We email your dispatch date. See delivery rates. Plain triangles: gusset plates. Plates to fit them to: base plate blanks.
What size is the snipe?
A 15 mm × 45° chamfer at the right-angle corner.
Are they rated for structural loads?
We supply the plates only and make no structural claims. Follow your engineer’s design for load-bearing work.
Are these laser cut?
No. They are plasma cut and deburred, so edges show a plasma-cut finish and are not held to laser-cut tolerances. For tight-tolerance parts, send us a drawing.